Happymodel Mobula6 1S 65mm5.8G VTX TinyWhoop Drone w/KV25000 brushless Motor BNF

Description

Happymodel Mobula6 1S indoor brushless tinywhoop racing drone is specially designed for indoor flying. Mobula6 is a highly  integrated ultralight tiny whoop. It is small and portable, the weight is only 20g. It comes with the newly highly integrated integrated Crazybee F4 Lite flight controller with OSD, Dshot ESC, 2.4G SPI receiver, 5.8G VTX, 0802 motor
25000KV
motor with 31mm propeller. Mobula 6 is your best choice for indoor flying this winter.
Specifications:
Item Brand: Happymodel
Item Model: Mobula6 1S 65mm Brushless whoop drone
Wheelbase: 65mm
Size: 80mm x 80mm x 37mm
Weight: 20g(without battery)
Features:
1.AIO 4IN1 Crazybee F4 Lite flight controller built-in 5.8G VTX
2.Extreme light 1S 65mm Brushless whoop only 20g
Runcam Nano3 The lightest 1/3 CMOS 800TVL Camera
3.Smooth and powerful
4.Compatible for 1S Lipo/LIHV
5.Camera Angle adjustable
Receiver option:
Internal SPI Frsky version (Compatible with ACCST D8/D16, Recommend D8 mode)
Package includes:
Mobula6 1S 65mm whoop Drone Frame x 1
Crazybee F4 Lite flight controller x 1
SE0802 KV19000  brushless motor x 4
Gemfan 1219-3 Propellers(4cw+4ccw) x 1
Runcam Nano3 1/3 CMOS 800TVL camera x 1
Frsky SPI D8 Receiver x 1
5.8G 25mw 40ch vtx (Flight controller built-in) x 1
1S Lipo/LIHV USB Charger x 1
Propeller disassemble tool x 1
Spare parts specifications:
Motor
Mode: SE0802 19000KV or KV25000
Configu-ration:9N12P
Stator Diamter:8mm
Stator Length:2mm
Shaft Diameter:Φ1mm
Motor Dimension(Dia.*Len):Φ10.5mm*14.9mm
Weight(g):1.9g
No.of Cells(Lipo):1S only
Propellers
Gemfan 1219-3
Center Thickness:5mm
Prop Disk Diameter:31mm
Center Hole Inner diameter:1.0mm
Weight:0.28g
Flight controller
(Frsky SPI RX version) CRAZYBEE F4 Lite Frsky version Firmware target: CrazybeeF4FR
(Flysky SPI RX version) CRAZYBEE F4 Lite Flysky version Firmware target: CrazybeeF4FS
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Power supply: 1S battery input (DC 2.9V-4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD(SPI Control)
Built-in 5.8G VTX
Built-in SPI Frsky/Flysky receiver
Built-in 5V 1A BEC
Built-in voltage detection
Onboard 4in1 ESC
MCU upgraded to EFM8BB21
Power supply: 1S LiPo/LiPo HV
Current: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: O_H_5_REV16_7.HEX
Default protocol: DSHOT600
Onboard
Frsky
SPI D8
receiver Version
SPI BUS receiver Frsky D8 compatible
Compatible Non EU transmitter D8 model
Channels: 8ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
Onboard
F
ly
sky
SPI
receiver Version
SPI BUS receiver
Protocol: AFHDS and AFHDS-2A Switchable
Channels: 8ch(AFHDS) or 14ch(AFHDS-2A)
No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m
Failsafe support
Onboard 5.8g
VTX
Output power: 25mw
Frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Frequency: 5.8GHz 5bands 40 channels
With Race band
Smartaudio ready
Runcam Nano3
Model: RunCam Nano 3
Image Sensor: 1/3" CMOS
Horizontal Resolution: 800TVL
Lens : 2.1mm(M8) FOV 160°
Signal System: PAL/NTSC Non Switchable
S/N Ratio: >50dB
Electronic Shutter Speed: Auto
Auto Gain Control (AGC): Auto
Min. Illumination: [email protected]
D-WDR: Auto
Day/Night: Color
Power:DC 3-5.5V
Current: 110mA@5V  [email protected]
Housing Material: ABS
Net Weight: 1.2g
Dimensions: L14mm*W14mm*H9mm
Lipo Battery
Capacity:300mAh
Voltage:3.8v
Continuous Discharge Rate: 30C
Size: 57mmx12mmx7mm
Weight: 8g
Connector: PH2.0
On Mar-09-21 at 18:58:06 PST, seller added the following information:
On Jul-06-21 at 02:30:48 PDT, seller added the following information: