Ethix Mr Steele Stout V4 2306 1750KV Motors

Description

The wait is over!
I would like to Introduce the Mr. Steele V4 STOUT 2306 (1750KV) 6S FPV freestyle motor.
I take great pride in my work and am always trying to raise the bar. After two years of seemingly nonstop research & development, I am proud to present this fine piece of Miniquad motor engineering.
V4 Motor Highlights and Changes
Base redesign 16x16(only) mounting holes (structural changes for more durability)
Complete bell redesigned (durability and smoothness in mind)
Thicker single strand copper winding
Increased EFFICIENCY & POWER
Complete Interchangeable motor pants redesign (thicker & more crash/low temperature resistant, better gap fitment, + more protection coverage for the “tall pants”)
Better assembly tolerances
Overall QC improvements
9mm steel bearings
Eco-Friendly packaging
Motor weight 31.8g
(full-length cables) compared to Stout V3 at 30.5g
Pants Weight
Low - 1g vs (0.8 v3)
Tall - 2g vs (1.8 v3)
All in all this motor is an absolute gem only increasing the weight by a tad over 1g from the previous model while achieving more power, efficiency, and most importantly durability.
V3 - V4 Compatibility
V4 and V3 motors are completely cross-compatible.
V3 bells - V4 stator
V4 bells - V3 stator
(everything is interchangeable except pants) The pants are stator-specific and can be interchangeable but with less than desired effect.
Enjoy & Thank you for your continued support.
-Steele
Specifications
:
Stator Size (Diameter): 23mm*6mm
Kv: 1750kv
Magnets: N52SH Curved
Windings: 15turn DLRK
Shaft Length (mm): 11.5mm
Shaft Diameter (mm): 4mm
Shaft material: Steel
Bearing: NMB684
Weight (With Wires) (g): 32.4g
Cells (Lipo): 6S
Max Current (A): 45A
Max Burst Current (A): 50A
Internal Resistance (Rm): 100mΩ
Wire Spec (AWG): 20#-135mm
Base Mounting Pattern: 16x16mm
Base Mounting Thread: M3 Thread
Motor Overall Dimensions: φ28.6mm*17.5mm
Includes
:
1x Ethix Mr Steele Stout Motor V4
1x Tall Motor Pants
1x Short Motor Pants
4x Motor Screws
1x Prop Nut